Troubleshooting Guide My pet does not press a button. The indicator light on the Remote or Receiver Collar comes on momentarily when any of the Mode Buttons is pressed.The indicator light on the Remote or Receiver Collar will not come on.The 3 bar indicator on the Remote LCD shows just 1 bar.The indicator light on the Receiver Collar is emitting a red color every 4 seconds or flashes rapidly.The unit need to be charged under any of below situations Then follow the above pairing steps from 2-4.ĭevice Information Product Specification Battery Type Use the Button on the Remote to select Dog 2. Press and hold Tone Button and Vibration Button at the same time for 2-3 seconds, the Green LED on the Receiver Collar will blink for 5 times indicating successful pairing.The Red & Green LED will blink for about 10 seconds indicating that it is ready for pairing.With the Remote turned on and the Receiver Collar turned off, press and hold the ON/OFF Button on the Receiver Collar for 4-5 seconds.Use the switch on the Remote to select Dog 1.Long press to turn on, long press to turn off. Slide up,control dog 1, slide down,control dog 2. Tone+Vibration: sends a vibration and Tone with 1-8 adjustable level to the Receiver Collar. Vibration: sends a vibration with 1-8 adjustable level to the Receiver Collar. Tone: sends a tone with non-adjustable level to the Receiver Collar. To reactivate, release and repress the button. NOTE: Continuous vibration will transmit for no more the 10 continuous seconds. Press the Vibration Button continuously for 1 to 2 seconds. To extend the life of the batteries, please turn the Receiver Collar off when it is not in use. Press and hold the On/Off Button until the Red LED light shuts off (This takes approximately 3 seconds). In normal mode, the Green LED will flash every 4 seconds, indicating the Receiver Collar is on and ready to receive a signal from the Remote.Press the On/Off Button the Green LED light comes on.Prepare the Receiver Turn on the Receiver Collar Long press the ON/OFF button to turn the remote OFF.LCD will be lighted, and show the information of current channel, battery power and levels.Long press the ON/OFF button to turn the remote ON.Please use the Output: DC 5V 500-800mA charger to charge the product.ĭon't use a charger that does not meet the specifications to charge the product. When you're not using the collar, please turn it off to increase the battery life.Excessive charging will shorten battery life. Please replace the rubber cover when the Receiver Collar is full charged.When fully charged, the red LED on the Receiver Collar will become The Battery Display of the Remote will stop cycling and appear full. For the initial charge, be sure to charge it for 4 hours.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |